Kenmore Elite 587.1468 Guide D'utilisation Et D'entretien page 10

Les langues disponibles

Care & Cleaning

Property Damage Hazard

Freezing temperatures may cause water lines to

rupture. Be sure all supply lines to and circulating

lines within dishwasher are protected.

Failure to do so could result in property damage.

Cleaning the Spray Arm

The spray arm may need to be cleaned to insure that

there are no clogs to the spray arm jets and bearings

due to hard water chemicals.

To remove spray arm simply hold the spray arm in

place and turn the retaining nut clockwise and pull up

on the spray arm lifting off the shaft.

To clean the spray arm use warm soapy water using a

soft brush to clean the jets and bearings.

To replace the spray arm simply set the spray arm on the

shaft, take the retaining nut and turn it counter clockwise

till it has locked into place.

All manuals and user guides at all-guides.com

Cleaning the Filter

For optimum performance, your dishwasher is equipped

with a filter assembly featuring a main filter, cup and

fine filter as shown in the drawing above. All food

fragments are removed from the dishwasher as water

passes through the filter assembly.

Each part of the assembly should be cleaned often to

ensure that all food fragments are removed from the

dishes. To remove food fragments from the filter

assembly, the filters must be removed from the

dishwasher. To remove the filters, pull up on the edge

of the main filter. Next, rinse the main filter and fine

filter under running water. Cleaning with a brush may

also be necessary to remove any fragments trapped in

the filters. Once cleaning has been completed, simply

reassemble the filter as shown in the drawing above. To

ensure that the filter is fully seated, please press down

on the top of the main filter. U U U U U sing the dishwasher

without a properly installed filter is not

recommended as it will reduce the cleaning

efficiency and may damage dishware.

sing the dishwasher