emerio CG-109898.1 Mode D'emploi page 6

CG-109898.1
PARTS IDENTIFICATION
1. Handle
2. Hinge release lever
3. Upper non-stick plate
4. Bottom non-stick plate
5. Power light
6. Heating light
7. Thermostat knob
8. Bottom housing
9. Upper housing
10. Oil drip tray
BEFORE INTITIAL USE
1. Remove all packaging.
2. Clean the surfaces with a soft damp cloth then dry them. Never immerse the grill in water or other liquids.
Do not immerse the appliance and do not run water directly on the cooking surfaces. Dry with a cloth or paper
towel.
3. Unwind the mains cable completely.
Note: When your grill is heated for the first time, it may emit slight smoke or odor. This is normal and harmless.
HOW TO USE
For best results, lightly coat the cooking plates with a little cooking oil or cooking spray.
⚫
Rotate the thermostat knob to select your desired heating level.
⚫
At first, try a setting in the max. You may later adjust it lower or higher according to your preference.
Close the grill and plug it into the wall outlet. You will notice that the power light and the heating light come on,
⚫
indicating that the appliance has begun preheating.
During the whole process, the heating light will turn on to indicate the grill is heating and turn off to indicate the
⚫
setting temperature has been reached.
Open the grill, put the sandwich, meat or other food on the bottom cooking plate.
⚫
Close the grill. The cooking will take about 3 to 8 minutes depending on different food.
⚫
- 5 -
EN