Publicité
Les langues disponibles
Les langues disponibles
To remove a shelf from the metal frame:
1. Pull shelf out to the stop.
2. Tilt front of the shelf up and pull it out a little farther.
3. Lift up shelf so that it moves through the slot in the
frame.
Replace the shelf in the reverse order.
Shelves and Shelf Frames
To remove a shelf/frame:
1. Tilt up front of the shelf/frame.
2. Pull shelf/frame.
To replace a shelf/frame:
1. Guide the rear shelf hooks into the slots in the shelf
supports on the back refrigerator wall.
2. Tilt up front of shelf/frame.
3. Lower the front of the shelf into position.
Lateral Adjustable Shelf
(on some models)
To slide the shelf from side to side:
1. Lift up on the front of shelf and slide to the desired
location.
2. Lower shelf to the level position.
NOTE: You do not have to remove small items from the
shelf before moving it from side to side. You may need to
remove larger items.
To remove the shelf:
NOTE: The shelf is heavy and must be removed using both
hands.
1. Remove all items from the shelf.
2. Hold the back of the shelf with one hand.
14
All manuals and user guides at all-guides.com
3. Lift the front of the shelf with the other hand to a 45°
angle and lower it slightly to release it from the upper
channel of the track.
4. Pull the shelf straight out.
To remove the shelf track:
1. Lift both sides of the track slightly.
2. Pull straight out.
To replace the shelf track:
1. Guide the track hooks into the shelf support slots on
the back wall.
NOTE: Make sure that both sets of track hooks are in
the slots and that the slots are parallel with each other.
2. Push the track back and down securely into the shelf
supports.
To replace the shelf:
NOTE: Make sure that both of the rear shelf slides are
securely in the track before letting go of the shelf. The
lateral shelf may be difficult to install if the track is placed
too close to the refrigerator ceiling. Reposition the track on
a lower rung until the shelf can be tilted enough to easily
slide into the track.
1. Hold the shelf at the front and tip the front at a 45°
angle to the track.
2. Insert both of the rear shelf slides into the upper
channel of the track.
3. Lower the front into place.
Publicité
