Forch BT-D 6-12 V Mode D'emploi page 11

START-STOP BATTERY TEST
Press the ◄ ► key to select START-STOP Test. In this stage, you will find the 3 tests for
■
selection.
BATTERY TEST
START-STOP TEST
SYSTEM TEST
Press the ◄ ► key to select battery type:
■
a. EFB
b. AGM FLAT PLATE
Press «ENTER» to confirm choice.
Press the ◄ ► key to select the battery rating: SAE (CCA), EN, IEC or DIN. Press «EN-
■
TER» to confirm choice.
Press the ◄ ► key to input the battery capacity:
■
SAE (CCA): 40~2,000
EN: 40~2,100
DIN: 25~1,300
IEC: 30~1,500
Press «ENTER» to begin test.
■
Press the key to confirm the position of the battery if the surface charge is detected. Fol-
low the tester 's steps to remove the surface charge if it happens.
■ Testing battery.
When test is completed, the display shows the results as following {Press the◄ ►key to
■
select: SOH (STATE OF HEALTH) or SOC (STATE OF CHARGE)}.
GOOD & PASS
The battery is good & capable of holding a charge.
GOOD & RECHARGE
The battery is good but needs to be recharged.
RECHARGE & RETEST
Battery is discharged, the battery condition cannot be
determined until it is fully charged. Recharge & retest the battery.
BAD & REPLACE
The battery will not hold a charge. It should be replaced
immediately.
BAD CELL & REPLACE
The battery has at least one cell short circuit. It should be
replaced immediately.
■ End of test. Precede the printout if needed.
BATTERY TEST
Press the ◄ ► key to select Battery Test. In this stage, you will find the 3 tests for
■
selection below.
START-STOP TEST
BATTERY TEST