Haier DW9-TFE1 Serie Mode D'emploi page 11

All manuals and user guides at all-guides.com
How to fill rinse aid
Rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door .
When the low rinse aid indicator "H"on the control panel and the
mechanical indicator "H1" on the dispenser light, you must load
rinse aid.
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your appliance,
you must proceed as indicated below when loading the rinse aid.
To open the dispenser, turn the "1" cap in an anti-clockwise direction
and then pour in the rinse aid, making sure not to overfill. The amount of
rinse aid used for each cycle can be regulated by turning the " 2" dose
adjustor, located beneath the "1" cap, with a screwdriver. There are 6
different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-
ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white
streaks, turn the dosage adjustor to a lower setting.
How to fill the detergent dispenser
Detergent
Detergent specifically intended for use with dishwashers must be used.
The dispenser must be refilled before the start of each wash cycle fol-
lowing the instructions provided in the "Programme overview". The de-
tergent dispenser is located on the inside panel of the door.
Loading the detergent
To open the " 3 " cover on the dispenser, press the "4" button.
The detergent for the wash cycle should be poured into the " 5 "
compartment.
The detergent for the pre-wash cycle should be poured into the "
6 " compartment.
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any excess detergent on the edges of the dispenser.
(DW9-TFE2/TFE3 series)
H
I
H1
1 2
4
3
6
5
EN
11
11