RIDGID WD2060 Mode D'emploi page 6

Vac Assembly
1. Line up vacuum port in top assembly
with drain cap located on the front of
the drum.
2. Place lid on top of drum with the han-
dles snug against the drum channel.
3. Be sure lid completely covers the top of
the drum so leakage does not occur.
4. Push down on top of the locking tab
areas to cause the flexible locking tabs
to hook onto the drum lip of the chan-
nel.
5. Make sure that the locking tabs are
snapped in place to prevent the lid from
coming off. (See inset)
6. Rotate both drum latches down until
you hear them snap over lip of the
drum.
Your new wet/dry vac is ready for use.
Top Assembly
Drum
Channel
All manuals and user guides at all-guides.com
Cord Wrap
Blower
Port
Power
Cord
Dust
Drum
Caster Feet
w/Accessory
Storage
Cord Storage
Simply, wrap the power cord around the
power head and snap the connector on
the plug to a wrap of the cord..
Push
Down
Pull Out
Drum
Latch
Tab
6
Area
Drain Cap
Drum
Latch
Out
On-Off Switch
Pull
Handle
Hose
Casters
Drum