Publicité
Les langues disponibles
Les langues disponibles
*
STEP 4 Leveling your washer
WA7700J-03520D-07-EN.indd 25
A
A
NOTE
Connect the hose guide (A) within 4 in (10
cm)* from the end of the drain hose. If the
drain hose is extended more than 4 in (10
cm) beyond the end of the hose guide, mold
or microorganisms could spread to the
inside of the washer.
NOTE
The drain hose can be installed to a 96
in (245 cm) maximum, but the draining
capability can be reduced at this height.
It can cause the washer to have an odor
because of remaining water in the drain
system.
NOTE
If the drain hose is installed below 39 in (99
cm), water can be drained in cycles due to a
siphon phenomenon. It causes the washer to
display "4C".
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below the
pulsator level.
NOTE
WA48J* models have the Built-in sink over
the pulsator level. That's why the level is not
revealed. Open the Built-in sink and check
the level with eyes.
English 25
2015/12/22 15:39:46
Publicité
