EuroLite RGB Flood-1500 DMX Mode D'emploi page 23

Connection with the mains:
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the effect to the mains, the RGB FLOOD-1500 DMX start running. You can adjust the
sensitivity with the rotary-control on the rearpanel.
Master/Slave-Operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the RGB FLOOD-1500 DMX you can find DIP-switches, which can be used for
connecting several devices.
Via the DIP-switches, you can adjust Master and Slave functions:
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the OUT-jack with the IN-plug of the next device.
Connect the device to the mains with the power-plug.
International
L
N
23/49 00026012.DOC, Version 1.2