Publicité
Les langues disponibles
Les langues disponibles
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
9.4
STAND THE MACHINE ON END
Figure 10.
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
Storage Switch
The machine has a storage switch that prevents its startup in
the storage position.
It is necessary to remove the safety key and the battery pack
to prevent accidental startup or unapproved use. The storage
switch does not replace this function.
10
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The bail switch is
defective.
The battery key is
not put in.
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does
Wet grass clip-
not mulch correct-
pings attach to the
ly.
deck.
The mulch plug is
missing.
English
Problem
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
* If you cannot find the solution to these problems, go to the
pack.
service center.
Replace the bail
11
switch.
Put in the battery
Voltage
key.
No load speed
Deck size
ing area.
Height adjustments
Move the wheels
to a higher posi-
Functions
tion.
Wait until the
Weight (without battery
grass dries before
pack)
mowing.
Battery model
Install the mulch
plug.
11
Possible cause
The grass is too
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
The blade is un-
balanced and
worn.
The motor shaft is
bent.
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
40 V
2800 RPM
21"
1 3/8 - 3 3/4" (3.5 - 9.5 cm)
3-in-1 Mulch & Rear Bag &
Side Discharge
57.32 lbs (26 kg)
BAF705 and other BAF ser-
ies
EN
Solution
Increase the blade
height.
Empty the grass
clippings from the
grass catcher.
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.
Publicité
