marklin 185 Serie Mode D'emploi page 10

Safety Notes
• This locomotive is to be used only with an operating system
designed for it (Märklin AC, Märklin Delta, Märklin Digital or
Märklin Systems).
• Use only switched mode power supply units and transformers
that are designed for your local power system.
• This locomotive must never be supplied with power from more
than one transformer.
• Pay close attention to the safety notes in the instructions for
your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 74046 interference
suppression set is to be used for this purpose.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
Important Notes
• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or spare
parts.
• The warranty card included with this product specifies the
warranty conditions.
• www.maerklin.com/en/imprint.html
Functions
• Recognition of the mode of operation: automatic.
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: 18 537 DB
10
All manuals and user guides at all-guides.com
• Addresses that can be set:
• Address set at the factory: (MM) 18 / (DCC) 03
• Adjustable Acceleration delay (ABV).
• Adjustable Braking delay (ABV).
• Adjustable maximum speed.
• Smoker generator built at the factory.
• Setting the locomotive parameters (address, acceleration/
• Headlights, changing over with the direction of travel.
• Only the smoke, running, and light changeover functions are
• Mode of Operation: Locomotive Engineer
• Additional explanations about the mode of operation can be
Note
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
If two or more digital protocols are recognized in the track, the
decoder automatically takes on the highest value digital pro-
tocol.For example, if mfx & MM are recognized, the mfx digital
protocol is taken on by the decoder.
1 – 80 (Control Unit 6021/Mobile Station 60651/652)
1 – 255 (Central Station 6021x/Mobile Station 60653)
braking delay, maximum speed):
with the Control Unit, Mobile Station, Central Station.
available in analog operation.
found in the supplemental instructions (included).
Priority 1: mfx
Priority 2: DCC
Priority 3: MM