Publicité
Les langues disponibles
Les langues disponibles
Install the Vacuum Breaker and Valve (cont.)
Turn on the water supply.
3. Verify Valve Function
NOTE: The valve is programmed with a 24-hour cleaning flush
feature.
Approach the fixture and stand in front of the sensor.
After 10 seconds, step away from the fixture. After a short delay,
the valve should flush.
Confirm that the flush ends.
Later, verify that the valve performed the 24-hour cleaning flush.
NOTE: If required, troubleshoot according to the Troubleshooting
Table in the Maintenance Guide.
Kohler Co.
7
1108709-2-A
Publicité
