Kohler K-10673 Instructions D'installation page 2

Tools and Materials
Strap
Wrench Hacksaw
Thread Sealing
Compound
Before You Begin
For K-10673 and K-10674 New Installation Only
IMPORTANT! The sticker covering the sensor eyes must remain in
place when valve is not installed.
Install the fixture according to the manufacturer's instructions.
Install rough water supply piping according to the roughing-in
illustration.
Flush the supply piping in order to remove any debris from the
supply line.
Shut off the main water supply.
This atmospheric vacuum breaker shall not be subjected to a
continuous pressure for more than twelve hours.
The device shall be installed in accordance with the requirements
of the local plumbing code.
The device shall not be installed where the venting of water from
the device, during normal functioning, causes damage.
The device shall be installed downstream of the last valve.
For K-10677 Retrofit Installation Only
IMPORTANT! The sticker covering the sensor eyes must remain in
place when valve is not installed.
Turn off the water supply to the fixture prior to performing any
installation modifications.
1108709-2-A
Blade Safety
Screwdriver Glasses
2 Kohler Co.