X-lite X-803 Sécurité Et Instructions D'utilisation page 20

X803
2.2 Repeat these steps with the right cheek pad padding.
Warning: once the inner paddings of the cheek pads in expanding foam have
been removed, make sure that the back snap button "D", the fastenings "A" and
the NERS safety lever "B" are correctly fastened to the rear frame of the fabric
lining of the cheek pads(Fig.16). Otherwise, correctly put them back.
3 DISASSEMBLY OF THE CHIN STRAP COVERING
To remove the chin strap covering from the strap, proceed as follows after removing the
cheek pads from the helmet (see instructions above).
3.1 Pull the left covering strap in line with the "hook and loop fastener" to separate it
from the chin strap band and then take it off (Fig.17A).
3.2 Repeat these steps with the right covering strap.
4 LINER DISASSEMBLY
4.1 Pull the back of the comfort padding towards the inside of the helmet to unhook
the two side buttons on its back from their seats on the rear support fixed to the
polystyrene inner shell (Fig.18).
4.2 Unhook the left front flap from the support fixed to the inner shell below the trim
of the upper edge of the shell by slightly pulling the comfort padding towards the
inside of the helmet (Fig.19). Repeat the same steps for the central front and right
front flaps.
4.3. Completely remove the comfort padding from the helmet.
5 LINER ASSEMBLY
5.1 Properly insert the comfort padding into the helmet.
5.2 Slip the left front flap of the liner into its seat by slightly deforming the upper shell
sealing edge (Fig.20). Repeat the same steps for the central front and right front
flaps.
5.3 Correctly turn up the shell sealing edge and press downwards in line with the three
front flaps (left, central and right) until they are fully fastened to the support. Make
sure that the front helmet area is as shown in Fig.21.
5.4 Fasten the two side buttons on the back of the rear part of the comfort padding
to the corresponding seats on the rear support fixed to the polystyrene inner shell
(Fig.18).
5.5 Spread out the inner comfort padding and make it stick to the inner shell by ap-
plying pressure first in the upper zone, so that the hook and loop fastener strap on
the top of the inside of the shell grips, and then along the circumference.
20
INSTRUCTIONS FOR USE