X-lite X-803 Sécurité Et Instructions D'utilisation page 17

DOUBLE ACTION
In the neutral (central) position, as illustrated in Fig.5, the DOUBLE ACTION device has
no effect on normal opening and closing functions of the visor.
The following additional functions can be activated by using the appropriate button.
1 DEFOGGING FUNCTION
1.1 While wearing the helmet, open the visor onto the first click and press the button
as shown in Fig.6. Now close the visor.
When set in this position, the mechanism keeps the visor open to a minimum
to improve circulation of air and facilitate defogging, especially at low speeds
or during short stops.
1.2 Press the button as shown in Fig.7 bringing it back to the neutral position, to de-
activate the defogging function.
2 VISOR-LOCK FUNCTION
2.1 While wearing the helmet, close the visor and press the button as shown in Fig.7.
When set in this position, the closing mechanism on the visor is strengthened
so that the likelihood of it accidentally opening will be reduced.
2.2 Press the button as shown in Fig.6 bringing it back to the neutral position, to de-
activate the visor-lock function.
WARNING
- When using the helmet, it is recommended that you limit your use of the visor-lock
function, since unexpected events may require you to open your visor immediate-
ly.
- In the event of an emergency, the visor-lock function may be disabled by lifting the
visor as normal, and pressing slightly harder than usual on the visor flap.
(Available as standard or accessory/spare part)
1 PINLOCK INNER VISOR ASSEMBLY
®
1.1 Disassemble the visor (see instructions above).
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.8).
1.3 Place the PINLOCK
The silicone-sealed profile of the PINLOCK
the inner surface of the visor.
1.4 Insert one side of the PINLOCK
in position (Fig.9).
inner visor on the visor.
®
inner visor onto one of the visor pins and hold it
®
inner visor must be in contact with
®
INSTRUCTIONS FOR USE
X803
17