Publicité
Les langues disponibles
Les langues disponibles
3. Place the tabletop onto the assembled firepit base. Secure the tabletop to the firepit base by
using four 1/4"x20mm bolts and Ø20xØ6.5x2.0mm washers as shown in Figure 3. Hand tighten
only.
Figure 3
4. Attach a complete leg to the firepit table top by using two 1/4"x35 mm bolts and
Ø20xØ6.5x2.0mm washers as shown in Figure 4a. Repeat for the other complete leg. Attach a
complete leg to the firepit base by using two 1/4"x30 mm bolts and Ø6.5x1.0mm washers as
shown in Figure 4b. Repeat for the other complete leg.
Figure 4a
Figure 4b
5. After making any necessary adjustments to the alignment of the firepit, use the hex bolt driver
to tighten all bolts. Repeat until all bolts are tight. Do not over tighten. Over tightening may strip
bolts. With the help of another person, turn the table in the upright position.
6. Place the burner pan protective ring into the firepan/burner assembly as shown in Figure 5.
Align the holes in the burner pan protective ring with the pre-drilled holes on the firepan/burner
assembly. Secure the burner pan protective ring to the firepan/burner assembly by using the M4
screws as shown in Figure 5.
Figure 5
7
Publicité
