Publicité
Les langues disponibles
Les langues disponibles
9
a) Turn hex jamb nut (flange
facing down) onto threaded
base of marker.
b) Insert square nut flat side
up into blade channel.
c) Align marker with edge
of blade, turn base fully into
square nut and tighten jamb
nut. Repeat for marker at
other end.
OPERATING INSTRUCTIONS
1. TO LOWER FOR PUSHING SNOW:
Step behind and remove keyhole pin. Lift one side of blade out of re-
tainer until slide hinge fits over the push bar, then lower blade to ground.
Re-insert keyhole pin. Repeat same procedure for other side of blade.
2. TO PUSH SNOW:
Drive forward slowly – blade will engage for pushing. When push is fin-
ished, driving in reverse disengages the blade until you are realigned for
next push. Repeat this procedure until job is finished.
3. TO STORE BLADE FOR TRANSPORTING:
Reverse procedure from Step 1 and re-insert keyhole pins.
4. TO STORE BLADE DURING OFF SEASON:
For maximum blade life, periodically retighten bolts and protect blade
from sun by storing it inside or covered.
Keyhole pins
secure blade
during trans-
porting
All manuals and user guides at all-guides.com
Keyhole pins
reinstalled to
secure blade
during plowing
Blade marker
aligned with
edge of blade
Threaded base
on marker
Hex jamb
nut
Insert square
nut flat side
up into chan-
nel on blade
5
Publicité
