Publicité
Les langues disponibles
Les langues disponibles
6
a) Insert 2 square nuts in channel at end of blade and slide them
over to line up with holes at top of slide hinge.
b) Insert bolts through holes in slide hinge and thread onto nuts
inside blade.
c) Make sure both lower holes in slide hinge are still in line with mark
on blade, then tighten 2 top bolts. Repeat at other end.
3/8" x 3/4" bolt
3/4" washer
7
a) First, with rubber centered on blade, use both lower holes in each
slide hinge as guide to drill 5/16" holes through first layer of alumi-
num and partially into rubber. Then turn 3/8" x 1" self threading bolt
into each hole and tighten to secure each hinge.
b) Second, at factory
mark near each end of
blade, drill 5/16" hole
through first layer of alu-
minum and partially into
rubber. Turn 3/8" x 1" self
threading bolt into hole
and tighten.
a) Hang blade assembly into retainer grooves on push frame.
8
b) Insert keyhole pins into holes on push frame.
Insert keyhole pin in hole, rotate pin just
enough to allow it through second hole
and rotate it back to its secure position.
4
All manuals and user guides at all-guides.com
2 Square Nuts
Flat Side Up
10172
These holes in hinge line up w/
factory marks on blade (to set
hinges 22 ½" apart)
Slide hinge
1st
2nd
3/8 x 1" self
threading bolt
Keyhole
pin
2nd
Publicité
