Publicité
Les langues disponibles
Les langues disponibles
a) Each end of the rubber cutting edge has two factory marks (to
3
match with holes in skid bracket). Drill them out with 5/16" bit.
b) Mount skid bracket there. Tighten bolts until head sinks flush with
rubber surface. Repeat at other end.
1/4" x 1-1/2"
bolt
Rubber cutting
edge
4
a) Align groove on rubber with groove
in blade, so skid brackets face back of
blade.
b) Slide rubber into channel in bottom
of blade and center it. (See Illustration
in Number 5).
NOTE: Rubber should be
room temperature before
assembly
a) Locate factory marks
5
on back of blade. Place
slide hinge on blade and
align both lower holes
with marks on blade.
TIP: When mounted-slide hinges should measure about 22 ½" apart.
All manuals and user guides at all-guides.com
Skid bracket
Factory marks for hole
locations on blade
Factory marked
hole locations
Lock washer
TIP: When
mounted-skid
bracket should
Nut
align flush
with or slightly
above bottom
Flat washer
of rubber.
Aluminum
blade
Skid brackets face back
side of aluminum blade
Back side fo
blade
Slide hinge
3
Publicité
