Publicité
Les langues disponibles
Les langues disponibles
TOOLS NEEDED:
• Drill with 5/16" bit
• 9/16" socket w/ ratchet
• 3/4" box wrench (2)
• 9/16" box wrench (1)
• 7/16" box wrench (1)
• Allen wrench 3/16"
• Protective eyewear
1
TIP: In some
cases, clearance
under receiver
may be less
than 8 inches. If
so, plow will still
operate properly,
but ground
clearance will
be limited. Use
Receiver
care on uneven
clearance
surfaces.
2
6"-8"
a) With bolts snug tight, level
push frame horizontally.
Shim here
WHEN SHIMMING IS COMPLETE – TIGHTEN ALL 4 BOLTS.
2
All manuals and user guides at all-guides.com
Note: Prior to plow assembly, park
vehicle on level grade and install new
front plow mount receiver (sold sepa-
rately). Clearance under front or rear
receiver should measure between 8 to
14 inches above grade.
Interceptor can be installed with leg turned up or down as
needed for proper push frame clearance (shown turned up in
illustrations)
Push
frame
4 bolts
1/2" x 4"
8 fl at
washers,
4 lock
nuts
Push frame
clearance
8-14"
6"-8"
Bubble level
6"-8"
Shim
here
a) Insert interceptor into
receiver – leg up. Secure with
pins. Hold push frame against
interceptor. Select 4 bolt hole
pattern that positions push
frame 6" – 8" above grade. If
lowest bolt pattern is too high,
remove interceptor and turn leg
down. Bolt push frame (4 bolts
1/2" x 4" w/ fl at washers and
lock nuts) to proper hole height
on interceptor – leave bolts
snug tight for now.
b) Push set collar tight against
receiver – hold and tighten set
screw with 3/16" allen wrench.
b) Check push frame for vertical
plumb. If plumb, tighten 4 bolts
now and go to step 3. If not plumb
– refer to shim procedure at left.
c) If push frame leans towards
front of vehicle, shim at top pair
of bolts. If push frame leans away
from front of vehicle, shim at bot-
tom pair of bolts.
Bubble level
Publicité
