IKEA UPPLEVA Mode D'emploi page 22

─ Schedule Type:
• Set Reminder to be reminded that you
can switch to the scheduled programme
when the time you have set comes. When
time is out and you do not execute any
operation, the dialog box will disappear
and no further operation will be executed.
• Set Record to check if you really want
to start your scheduled recording when
the time you have set comes. When
time is out and you do not execute any
operation, scheduled recording will start
automatically.
─ Repeat Type: set different repeat
modes for the recording.
4. Press / / / to select Add, then
press OK to add the schedule you set
into your schedule list.
5. Press the red button to repeat above
procedures to add another schedule.
6. If you wish to edit or delete a schedule,
select it and press OK to enter.
7. Press EXIT to close the menu.
Network connection
You can set up your TV so that it can access
the Internet through your local area network
(LAN) using a wired or wireless connection.
Connecting to a wired network
You can attach your TV to your LAN using
cable in three ways:
• You can attach your TV to your LAN by
connecting the LAN port on your TV to an
external modem using a Cat 5 cable.
• You can attach your TV to your LAN by
connecting the LAN port on your TV to
an IP Sharer, which is connected to an
external modem. Use Cat 5 cable for the
connection.
• Depending on how your network is
configured, you may be able to attach
your TV to your LAN by connecting the
LAN port on your TV directly to a network
wall outlet using a Cat 5 cable. Note that
the wall outlet is attached to a modem or
router elsewhere in your house.
Select SETUP > Network > Settings >
Interface, then select Ethernet to connect
to a wired network.
Connecting to a wireless network
To connect your TV to your network
wirelessly, you need a wireless router or
modem and a WIFI-adapter, you will have to
All manuals and user guides at all-guides.com
buy one separately. Connect WIFI-adapter
to your TV's USB 1 port.
1. Select SETUP > Network > Settings
2. Select Wireless Setting and press
3. Connection Methods: You can setup
─
• Select Wireless Setting > Scan, then
• Select an available access point, then
Notes:
─
─
─
─
• PIN: Select PIN and press
• PBC: If your router has a PBC push
> Interface, then select Wireless to
connect to a wireless network.
OK/
to enter.
the wireless network connection three
ways.
Scan
press OK/ , the TV will scan all access
points within range. The access points
found by the TV will be displayed.
OK/
press to connect the TV.
If you select a protected access point,
you will have to enter the corresponding
password. Press OK on the remote
control to display the virtual keyboard to
enable you to enter the password.
This TV has a memory function of
available access point, which enables
your TV to be connected to the network
even if you switch on the TV after power
off.
Manual
Select Wireless Setting > Manual,
then press OK/ , you will be prompted
to enter the correct SSID of an available
wireless router to set up the connection.
Auto
If your AP supports WPS (Wi-Fi
Protected Setup), you can connect to the
network via PIN (Personal Identification
Number) or PBC (Push Button
Configuration). WPS will automatically
configure the SSID and WPA key in
either mode.
Select Wireless Setting > Auto, then
press OK/ to enter.
enter. Generate a random PIN code.
Make sure this code is installed on the AP.
(For the procedures, refer to your router
manual.) Press OK/
connection.
button, select PBC, then press
enter. Press the PBC push button on your
router within 2 minutes after you press
OK/ again. Your TV will automatically
acquire all the network setting values it
20
OK/ to
again to set up the
OK/
to