Publicité
MADE IN CHINA. Colors and decoration may vary. Conforms to toy safety standards STM F963.
En dehors des heures de bureau: 0870 850 8408 Email: ukservice@spinmaster.com
Information Consommateur en Amérique du Nord / Téléphone: 1-800-622-8339 Fax: 416-364-8005 Web: www.spinmaster.com
FABRIQUÉ EN CHINE. Les coloris et la décoration peuvent varier. Conforme aux normes de sécurité en matière de jouet ASTM F963.
BATTERY INSTALLATION / REPLACEMENT
INSTALLATION ET CHANGEMENT DES PILES
2
Use a Phillips head screwdriver (not included) to remove battery cover
[ 1 ]. Remove batteries and replace with 3 "AAA" alkaline batteries in
the orientation shown [ 2 ]. Replace battery cover and tighten screw.
Use only alkaline batteries for longer life. Replace batteries if lights
and sounds play slowly or distort.
Get user manuals:
See SafeManuals.com
CUSTOMER SERVICE
À l'aide d'un tournevis cruciforme (exclu), retirez le couvercle du
compartiment des piles. [ 1 ] Retirez les piles et remplacez-les
par 3 piles alcalines AAA en les orientant comme indiqué. [ 2 ]
Remettez le couvercle du compartiment et serrez la vis.
Employez exclusivement des piles alcalines, qui durent plus
longtemps. Changez les piles si les voyants ou les sons
s'affaiblissent ou se déforment.
WARNING: If you have experienced light-induced seizures in the past, do not use this toy.
Nécessite 3 piles AAA (fournies).
T24324-0001-NBL-R0
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, used and can radiate radio frequency energy
and m if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which and be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and
receiver.
1
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV
technician for help.
BATTERY SAFETY INFORMATION
•
Non-rechargeable batteries are not to be recharged.
•
Rechargeable batteries are to be removed from the toy before
being charged (if designed to be removable).
•
Rechargeable batteries are only to be charged under adult
supervision (if designed to be removable).
•
Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries or different types of batteries.
•
Do not mix old and new batteries.
•
Only batteries of the same or equivalent type as recommended
are to be used.
•
Batteries are to be inserted with the correct polarity.
•
Exhausted batteries are to be removed from the toy.
•
The supply terminals are not to be short-circuited.
•
Dispose of battery(ies) safely.
•
Batteries should always be replaced by an adult.
•
Use alkaline batteries only for best performance.
LES PILES ET VOTRE SÉCURITÉ
•
Il ne faut pas recharger les piles non rechargeables.
•
Il faut retirer les piles rechargeables du jouet avant
de les charger (si on peut les retirer).
•
Les piles rechargeables ne doivent être rechargées que sous
la surveillance d'un adulte (si on peut les retirer).
•
Ne mélangez pas des piles alcalines et des piles ordinaires
(carbone-zinc) ou des piles rechargeables (nickel-cadmium).
•
Ne mélangez pas des piles anciennes et des piles neuves.
•
Il ne faut employer que des piles de même genre ou d'un genre
équivalent à celui conseillé.
•
Il faut retirer les piles épuisées du jouet.
•
Il ne faut pas court-circuiter les bornes d'alimentation.
Mettez les piles au rebut en respectant les usages.
•
Un adulte doit toujours procéder à l'installation des piles.
•
Servez-vous exclusivement de piles alcalines pour
un fonctionnement optimal du jouet.
Please remove packaging material before giving to child.
Ces instructions comportent des informations importantes.
Conservez-les pour pouvoir les consulter ultérieurement.
FEATURES
CARACTÉRISTIQUES
PLAYTIME
JEU
Move the ON /OFF/ TRY ME switch to the "ON" position.
Placez l'interrupteur TRY ME/OFF/ON (ESSAYEZ-MOI FERMÉ/
OUVERT) en position « ON », tel qu'indiqué.
MICROPHONE
ON / OFF SWITCH
INTERRUPTEUR
ON/OFF
KEYNOTE BUTTON
BOUTON PRINCIPAL
SPEAKER
HAUT-PARLEUR
= ON
= ON
= OFF
= OFF
Publicité
