Haier HD70-A82 Mode D'emploi page 20

TROUBLESHOOTING
Before contacting the customer service, please check the following
circumstances:
PROBLEM CAUSES
Tumble dryer – Poor connection to the
fails to operate.
– Power failure.
– No drying program is set.
– Device has not been
– The water tank is full.
– The door is not closed
Tumble dryer – The laundry has reached
fails to operate
and the display
shows END.
– There is no laundry in the
Drying time is – The program setting is not
too long and
the results are
– The filter is clogged.
not satisfac-
– The evaporator is blocked.
tory.
– The tumble dryer is
– The laundry is too wet.
– The vent duct is blocked.
Remaining time The remaining time will be
on the display adjusted continuously based
stops or skips. upon the following factors:
– Type of laundy.
– Loaded amount.
– Moisture degree of the
– Ambient temperature.
20 | English
All manuals and user guides at all-guides.com
power supply.
switched on.
properly.
the condition defined by
the program.
drum.
correct.
overloaded.
laundry.
SOLUTION
Check connection to the power
▪
supply.
Check the power supply.
▪
Set a drying program.
▪
Switch the device on.
▪
Empty the water tank.
▪
Close the door properly.
▪
Check if the program setting is
▪
appropriate.
Check if there is laundry in the
▪
drum.
Make sure the program is set
▪
correctly.
Clean the filter screen.
▪
Clean the evaporator.
▪
Reduce the amount of laundry.
▪
Spin the laundry properly
▪
before drying.
Check the vent duct and
▪
unblock it.
The automatic adjustment is a
normal operation.