Braun Silk-epil SuperSoft Plus EE 1670 Mode D'emploi page 10

water (e.g. a filled wash basin,
bathtub or shower).
• Keep the appliance out of the
reach of children.
• Before use, check whether your
voltage corresponds to the volt-
age printed on the transformer.
Always use the 2.4 V transformer,
type PI-41-90 V-2.
Description (see page 4)
Ö
Soothing attachment
Ü
Tweezer grip selector
á
Epilator head with
tweezer element
à
Release bar for epilator head
â
Switch lock
ä
Switch
ã
Charging indicator
å
Socket for cord connector
ç
Cord connector
é
2.4 V transformer with plug for
power socket
Underarm and bikini line epilation
Use tests monitored by dermatol-
ogists have shown that the epilator
head may as well be used underarm
and at the bikini line. Be aware that
these areas are particularly sensitive
to pain. However, the pain sensation
will diminish with repeated usage.
For this specific application, we
would like to give the following
advice:
• Before epilating, thoroughly clean
the respective area to remove
residue (like deodorant).
All manuals and user guides at all-guides.com
• Hair should not be longer than
• After use, apply Silk·épil cream or
How to operate your
Silk·épil
You can use your Silk·épil with or
without the cord.
• The charging indicator will light up.
• Best environmental temperature
• After charging, always unplug
• A full charge allows you to use
Then dry carefully with a towel
using a dabbing action to avoid
skin irritation.
5 mm.
baby powder (don't use alcoholic
deodorants).
Charging the appliance for cord-
less operation
Plug the cord connector into
the socket, plug the transformer
into an electrical outlet and
charge the appliance for
16 hours (switch position «0»).
range for charging: 15 °C – 35 °C.
the appliance and use it without
the cord until it is completely
discharged.
your Silk·épil for approximately
30 minutes without the cord.
Using the appliance with the cord
Your Silk·épil may also be oper-
ated directly from the mains, e.g.
if the cell unit is discharged. If the
appliance should not run immedi-
ately, charge it for approximately
1 minute (switch setting «0»).
11