hestan KSO 30 Manuel D'utilisation page 40

OVEN CARE AND CLEANING
REPLACING AN OVEN LIGHT
Each oven is equipped with three halogen lights per cavity located in the side walls of the oven.
EN
PRÉCAUTION
ELECTRICAL SHOCK HAZARD - Make sure the power has been shut off to the range. The light
socket is energized when the door is open. Failure to shut off the power when replacing a light
bulb could result in electric shock or burns.
• The lenses must be in place when using the
oven.
• The lenses serve to protect the light bulb
from breaking.
• The lenses are made of glass. Handle carefully
to avoid breakage. Broken glass could cause
an injury.
• Use only 20 watt, 12 Volt, halogen "Bi-Pin"
bulbs suitable for appliance oven use. This
type of bulb may be available at hardware
stores & home centers, or specialty lighting
stores.
Contact Hestan Customer Care for more
information.
TO REPLACE A LIGHT BULB
1. Turn off power at the main power supply
(fuse or breaker box).
2. In ovens with lateral rack supports, remove them by
unscrewing the four screws.
3. Place a thick towel or cloth on the oven floor below
the lamp to catch the glass lens should it fall.
4. Remove the lens retaining screw using a screw driver.
Then remove the lens.
5. Remove the light bulb from its socket by pulling it
straight out.
6. Before installation, it is very important to clean the
new bulb carefully with a clean, soft cloth, or tissue
paper. Grease, fingerprints, or oils in your skin can
leave a residue on the glass surface of the bulb which
will create a hot-spot. The bulb will eventually crack at
this hot-spot.
7. While still using a cloth or tissue paper, insert the new
bulb in the lamp housing. Push the bulb fully into the
socket.
8. Replace the lens and screw.
Replace the rack supports if provided. Turn power back on
at the main power supply (fuse or breaker box).
38
©2018 Hestan Commercial Corporation
All manuals and user guides at all-guides.com
(CONT.)