BORETTI BV88 Notice D'emploi page 34

3. Fasten the appliance with 4 screws
the kit included with the appliance.
4. From the plastic cover (E), which is used to cover
the hinge with the pivot pin, you must take away
the part as indicated in the drawing.
This operation is made easer since there is, in the
internal part of the cover hinge lid a groove that
facilates the removal of this coomponent.
"Remove the part marked with DX, if the pivot pin
is inserted in the right hinge, SX in opposite
case."
C
D
E
5. Apply covers (C-D) on joint cover lugs and into
hinge holes.
Snap vent grille (B) and hinge covers(E) into
position.
34
All manuals and user guides at all-guides.com
I
I
(I) provided in
E
B
Hb
Hd
PR266
6. Separate parts Ha, Hb, Hc, Hd
figure.
ca. 50 mm
ca. 50 mm
7. Place guide on the inside part of the furniture door,
up and down as shown in the figure and mark the
position of external holes. After having drilled
holes, fix the guide with the screws supplied.
Ha
Hc
PR33
8. Fix cover (Hc) on guide (Ha) until it clips into
place.
Ha
Hc
as shown in the
90°
90°