Black & Decker KC9072 Manuel D'utilisation page 26

ENGLISH
Screw size Pilot hole diameter
Softwood Hardwood Hardwood
No.6 (3.5mm) 2.0mm
No.8 (4.0mm) 3.2mm
No.10 (5.0mm) 3.5mm
HANDY HINTS
• Be careful to avoid over tightening small brass
screws. The heads are easily twisted off and the
threads can strip. Hand tightening of these screws is
recommended.
• Use Posidriv screws whenever possible; they are
easier to drive because the screwdriver bit engages
more firmly in the screwhead.
• In some cases it is advisable to lubricate the screw
thread to make the screwdriving easier. The usual
lubricants are soap or washing up liquid smeared on
the thread of the screw.
• When drilling in wood using a twist bit, pull the twist
bit out of the hole periodically to clear woodchips
from the flutes.
• When you insert a wood screw into a hole that is
already threaded, start the screw by hand to avoid
stripping the threads in the hole. Run the screw in
until you feel the threads catch, then use your
screwdriver.
RECHARGEABLE BATTERIES AND THE ENVIRONMENT
Black & Decker cordless tools use nickel
cadmium (NiCad) batteries or battery packs
which can be charged many times to give long
life and repeatedly full power.
This symbol indicates the NiCad batteries
contained within this unit must be disposed of
properly and not discarded in everyday
Cd
household waste which may be disposed of in
an incinerator or landfill site.
NiCad batteries can be harmful to the
environment and can explode when exposed to
fire. Do not incinerate. Therefore, when your tool
or battery pack needs replacing, think of the
protection of our environment.
Black & Decker recommends the following:
Discharge batteries completely by running the
unit until the energy is completely discharged
and then remove from the tool.
REMOVING THE BATTERIES
This should only be done when intending to discard the
tool, in order to recycle the batteries.
26
All manuals and user guides at all-guides.com
Clearance hole
2.5mm 4.0mm
3.5mm 5.0mm
4.0mm 5.7mm
EC DECLARATION OF CONFORMITY
We declare that units: KC9019, KC9038, KC9072
conform to 89/392/EEC, 89/336/EEC,
EN55014, 73/23/EEC, EN55104, EN50144
A weighted sound pressure 70dB (A)
A weighted sound power 85dB (A)
Hand/arm weighted vibration 2.5m/s
Colin Wills - Director of Engineering
BDC International Ltd, 4F. 2 Dia Wang Street,
Tai Po Industrial Estate, Tai Po, N.T. Hong Kong
The Black & Decker policy is one of continuous
improvement to our product and as such we reserve
the right to change the product specification without
prior notice.
Remove the two pins
securing the head of your
screwdriver. Remove the
casing retaining screw.
Strike the casing with a
soft-faced hammer to
separate the two halves.
Remove the batteries
from your screwdriver
and dispose of them in an
environmentally safe way.
2