Tristar MX-4143 Manuel D'utilisation page 18

UK
Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz. Place the device on a flat stable surface and ensure a
minimum of 10 cm. free space around the device. This device is not suitable for installation in a
cabinet or for outside use.
First use
-Read this handbook to familiarize yourself with all the parts of your new food processor.
-Clean all the parts and accessories in contact with food before using the appliance for the first
time (see paragraph "Cleaning").
Warning!
Always take care when you are handling the blades to fit them on, taking them out of the bowl
(B1) after preparing the food and when cleaning them, as they are very sharp.
Do not operate without the cover in place.
How to use it
Your new food processor will help you to prepare a lot of basic mixtures that you can use for
your recipes.
Please abide by the following instructions to achieve the best results and to keep your
appliance in good working condition.
Attention!
Never exceed the maximum quantities below and never pour liquids hotter than 75°C into the
bowl and/or blender.
Follow the instructions given below every time you use it:
-Never leave the appliance unattended while it is on.
-Never make the appliance work while it is empty.
-Never touch the moving parts.
-Never put your fingers or utensils inside the lid opening.
-Never press down the ingredients into the lid opening with your hands.
-Do not use the appliance to work hard ingredients (e.g, frozen meat, crusts of cheese...),
rubbery (e.g.candied peel...), uneatable parts of ingredients (e.g. bones,, fishbones...)or
crush ice.
-Do not remove the lid and never replace accessories without switching off the appliance and if
the accessory being used has not stopped working.
-Do not remove the ingredients from the bowl before removing the blade.
A: Mixing Bowl
I. Chopping Function
-put the protect cover onto the body tightly ,as shown in Diagram 1
-put the plastic bowl on power unit and turn the handle in clock-wise direction, as shown in
Diagram2&3
- Put the blade support on the axis in the middle of the bowl, and press it to the bottom.
Then fix the chopping blade to the blade support, as shown in Diagram 4&5.
Warning: The blade in sharp. Please only hold the plastic part while using.
- Put the food (eg. Meet) into the bowl, as shown in Diagram 6. Big piece food needs to be cut
into small pieces. ( 2 cm x 2 cm x 2 cm).
- Put the cover on the bowl, and turn it until hearing the chattering sound, as shown in
Diagram7.
18