Flex WST 700 VV Notice D'instruction D'origine page 20

To change:
 Press the two locks on the tool change head
(1.) and remove sanding head (2.).
klqb
qÜÉ=íêá~åÖìä~ê=ë~åÇáåÖ=ÜÉ~Ç=áë=~íí~ÅÜÉÇL
ÅÜ~åÖÉÇ=áå=íÜÉ=ë~ãÉ=ï~óK
Attaching and changing
the sanding tools
`^rqflk>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
 Place the sanding tool in the centre
of the sanding disc and press on.
The holes in the sanding tool must be in
alignment with the extraction holes in the
sanding disc!
For round sanding head only:
 Conduct a test run to check that the sanding
tool is clamped in the centre.
20
All manuals and user guides at all-guides.com
Adjusting rear handle
To optimise the power tool to the task, the rear
handle can be adjusted by pulling out/pushing
in the telescopic tube.
Adjusting range: approx. 400 mm
 Open lock on telescopic tube (1.).
 Pull out telescopic tube to the required
 Close lock again.
tÜÉåÉîÉê=~ÇàìëíáåÖ=íÜÉ=ëÅêÉïI=ÅÜÉÅâ=íÜÉ=
ÉÑÑÉÅíáîÉåÉëë=çÑ=íÜÉ=äçÅâX=áÑ=êÉèìáêÉÇI=êÉJ~Çàìëí=
íÜÉ=~ÇàìëíáåÖ=ëÅêÉïK
Connecting the extractor
qÜÉ=Éñíê~Åíáçå=ÜçëÉ=Å~å=ÄÉ=ÜçìëÉÇ=áå=íÜÉ=
ÅçîÉê=çÑ=íÜÉ=íê~åëéçêí=Å~ëÉK
 Connect extraction hose to the 32 mm
WST 700 VV / WST 700 ECO
length (2.).
klqb
klqb
connector.