Sime Home Plus Manuel D'installation Et D'utilisation page 16

– Or press the button
Confirm
area for the boiler
tings"
Parameter Index: 1
Parameter Value: 0
Esc
– where "Parameter index" refers to the parameter table in the
manual of the installed boiler (eg. 1=tS 0.1 or 1=PAR 01).
– Rotate the encoder
rameters and check the value
– If the value of the selected parameter is to be modified:
– Press the encoder
click
area
Parameter Index: 1
Parameter Value: 0
Esc
– Press the encoder
– Press the encoder
click
move on to another parameter.
16
All manuals and user guides at all-guides.com
to go into the "Parameter set-
Boiler parameters
1--------49
Back
to scroll through the list of pa-
to go into the value modification
Boiler parameters
1--------49
Back
to set the new value
to confirm the modification and
– Once all the displays/modifications have been completed,
press the button
Esc
Zona
Menu
TECHNICAL ASSISTANCE CENTRE Menu
m
WARNING
It is useful to enter the TECHNICAL ASSISTANCE
CENTRE references which can then be displayed in
the "Display Menu" and are suggested to the user if
there is a serious fault in the boiler.
To enter the TECHNICAL ASSISTANCE CENTRE references:
– follow the procedure described in section 4.2.3 on page 14
up to the section "go into the submenu".
– Rotate the encoder
submenu"Technical Assistance Centre" submenu.
TECHNICAL
Zone heating [...]
Hot water [...]
Boiler parameters [...]
Reset alarm history [...]
Factory total reset [...]
Esc Back
EN
to go back to the "main screen" .
Gi 18 Set 2014 10:30
Off
Modo
to select the required
TECHNICAL
Customer service [...]
Esc Back