Publicité
Les langues disponibles
Les langues disponibles
BASIC SHREDDING OPERATION
Continuous operation:
2-4 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
2-4 minutes will trigger a
15-minute cool down period.
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
1
2
Set to Reverse (R)
Alternate slowly back and forth
for 2-3 seconds
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects
in material and workmanship and provides service and support for 1 year from the date of purchase
by the original consumer. Fellowes warrants the cutting blades of the machine to be free from
defects in material and workmanship for 1 year from the date of purchase by the original consumer.
If any part is found to be defective during the warranty period, your sole and exclusive remedy will
be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does
not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder
operation using an improper power supply (other than listed on label), or unauthorized repair.
Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to
All manuals and user guides at all-guides.com
PAPER
1
2
Set to Off (O)
Set to Auto-On (I)
and plug in
CARD
1
2
Set to Off (O)
Set to Auto-On (I)
and plug in
3
4
Set to Off (O)
and unplug
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Set to Off (O)
3
Feed into paper
entry and release
3
Hold card at edge
6
5
Gently pull uncut
Set to Reverse (R)
paper from paper
entry. Plug in.
3
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
provide parts or services outside of the country where the shredder is initially sold by an authorized
attributable to this product. This warranty gives you specific legal rights. The duration, terms, and
conditions of this warranty are valid worldwide, except where different limitations, restrictions, or
please contact us or your dealer.
4
Set to Off (O)
4
5
Feed into center of
Set to Off (O)
entry and release
Shredder doesn't start:
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
3
Publicité
