Kenwood KDC-BT368U Mode D'emploi page 33

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from the
unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(supplied/commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes on
both sides of the trim plate, then pull it out.
3 Insert the extraction keys deeply into the slots on each
side, then follow the arrows as shown below.
Do the required wiring.
( 30)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Part list for installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
ENGLISH
29