Sharp SJ-EX770F Mode D'emploi page 7

Installation
1
Keep adequate ventilation space around the
refrigerator.
•
minimum required
space for installing
the refrigerator. The
measurement condition
of power consumption
is conducted under
a different space
dimension.
• By keeping greater
space, the refrigerator may consume a less amount
of power consumption.
• If use the refrigerator in the smaller space
rise in the unit, loud noise and failure.
• The space between the rear of the refrigerator and
the wall should be 60mm or more, and less than
75mm.
If the space is wider than 75mm, you may get
injured by touching compressor and its peripheral
parts which are extremely hot during the operation.
Overall space required in use
2
Use the two front the adjustable feet to place the
3
When right and left doors are not properly aligned,
adjust using the adjustable feet.
When the left door is
raised.
Lower the foot
at right side.
other side is slightly off-ground.)
All manuals and user guides at all-guides.com
90mm
or more
60mm 60mm
or more or more
1500 mm
Adjustable foot
When the right door is
raised.
Lower the foot
at left side.
4
Remove the 4 screws of the lower part of the cabinet
cover is packed inside the refrigerator compartment.)
Screw
(4 screws)
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
• When you insert the power plug with the door opened,
door alarm sounds but it is not abnormal. This sound
stops after closing the door.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm
water.
If soapy water is used, wipe it off thoroughly with water.
Free standing type Free standing type
Screw
Foot cover
7