Grundig SM 8680 Mode D'emploi page 17

OPERATION­______________________________
Preparation
Caution­
Switch off the appliance and disconnect it
█
from supply before changing accessories or
approaching parts that move in use.
1­­ R emove all packaging and sticker materials
and dispose of them according to the applica-
ble legal regulations.
2­­
T ake the entire unit of the motor housing
and place it on an even surface, e.g. on the
kitchen counter.
3­­ P ut the glass jug on the motor housing
D
Caution­
Do not remove the blade unit by lifting it from
█
the blades.
The blade unit is very sharp! Handle the blade
█
unit with utmost care, especially during clean-
ing, in order to avoid injuries.
4­­
C lean all parts, with the exception of the motor
housing as described in "Cleaning and Care".
Note
Make sure that the notches on the bottom of
█
the glass jug fit those in the motor housing.
5­­ C ut the food into small pieces before using the
appliance.
All manuals and user guides at all-guides.com
G
.
G
Blending­
1­­
P lace the device on an even and dry surface.
The non-slip feet ensure the stability of the
I
appliance.
2­­ M ake sure that the power cord is disconnected
from the power supply and the control dial
is on "0" before putting food into the glass jug
.
D
3­­
T ake the glass jug
D
by lifting the glass jug
G
the lid.
4­­ N ow put the ingredients to be blended in the
glass jug . The ingredients should only be
D
about 2-5 cm long.
Notes
Add water to ensure the jug blender functions
█
smoothly.
Mix 3 units of hard food and 2 units of water
█
in order to have a smooth jug blender experi-
ence. (i.e: 60 gr hard food 40 ml water)
Caution­
Do not put or blend hot food or liquids in the
█
glass jug. If you process soup, make sure that
the liquid temperature does not exceed 40°C.
To process crushed ice, we suggest you to start
█
with three quarters of ice in the jug and add 15
ml of cold potable water.
Don´t try to crush ice without adding water to
█
the jug.
Never let the jug blender operate while empty
█
(without food).
Never let the jug blender operate without the
█
glass jug on the motor housing.
5­­ C lose the lid . Make sure that the cap/ meas-
C
uring cup is inside the feeding chute and is
A
secured.
6­­
P lace the glass jug
D
housing .
G
H
from the motor housing
upwards and open
D
upright onto the motor
ENGLISH 17