Touch Calibration; Temperature Calibration; Service Information - Jenn-Air JJW3430 Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour JJW3430:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9. On double ovens, repeat steps 1-8 to set the second cavity, if
desired.
WARNING
Food Poisoning Hazard
Do not let food sit in oven more than one hour before
or after cooking.
Doing so can result in food poisoning or sickness.
10. (Optional) To set a Delayed Start, touch DELAY START and
set the desired time. See the "Delay Start" section for more
information.
11. Press START to begin heating the oven.
12. Press CANCEL OVEN (CANCEL UPPER or CANCEL LOWER
on double oven models) to turn off the oven.
To Disable Sabbath Mode:
Sabbath Mode will automatically be disabled when a cook time
ends, or can be disabled by pressing Cancel. "Sabbath Mode:
OFF" will appear on screen. To program a new cycle, follow steps
2 to 11 in the "To Use Sabbath Mode" section.

Temperature Calibration

1. From the Setup Menu, touch the button at the right-hand side
of screen beside Temperature Calibration.
2. On double oven models, select which oven to calibrate:
upper or lower.
3. Touch NEXT.
4. Select the temperature offset. Press -1° button if oven seems
too hot or +1° button if oven seems too cold. The oven can
be adjusted +/- 35°F.
5. Touch SAVE and the adjustment has been made.

Touch Calibration

IMPORTANT: If the buttons on the screen are difficult to touch
accurately, you may need to calibrate the touchscreen. This
process is recommended when the oven is installed under a
counter.
1. From the Setup Menu, touch the button at the right-hand side
of screen beside Touch Calibration.
2. You will be asked to touch and hold 3 targets to calibrate.
3. Touch NEXT.
4. Touch and hold the center of the targets for 2 seconds on the
screen.
5. Test calibration by moving the circle around the screen.
Ensure you can reach all the corners.
6. Touch TRY AGAIN to run calibration again.
7. If CANCEL is touched, the Touchscreen Calibration will be
canceled.
8. Touch SAVE. This will return you to the Setup Menu.
Reset All Settings To Factory Defaults
1. From the Setup Menu, touch the button at the right-hand side
of screen beside Reset All Settings to Factory Default.
2. Touch RESET or CANCEL.
3. If Reset is touched, the following sets will be lost: most used
modes/foods, My Creations, Date/Time, and Language. The
Welcome Guide will appear to help you reset these settings.

Service Information

For more information, see the "Assistance or Service" section.
1. From the Setup menu, touch the button at right-hand side of
screen beside Service Information.
2. Choose ON or OFF for Demo Mode. When Demo Mode is on,
the oven will not heat and "Demo Mode" will appear on the
left-hand side of the screen.
3. If CANCEL is touched, the Service Information will go back to
the default setting.
4. Touch SAVE. This will return you to the Setup menu.
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jjw3830

Table des Matières