WeatherTech 110133-120133 Instructions D'installation

Télécharger ce manuel

MudFlaps

Thoroughly wash your vehicle, removing all

dirt, debris and stains from each fender in the

areas where the MudFlaps will be installed.

Park the vehicle on level ground. Begin with

the driver's side MudFlap installation.

Locate the (3) three factory plastic fasteners at the

inner fender as indicated.

Put the inner fender back into place. Then, using the

MudFlap marked "LH," place it up to the fender and

align with the corresponding holes.

Installation Instructions

4 4

Using a trim clip remover, remove the (3) three factory

plastic fasteners by pulling the head of each fastener

up and each base out of the fender. They will not be

reused. Then, pull the inner fender back and install

(3) three supplied U-Clips over the factory holes as

indicated. Make sure the hole in each U-Clip is lined

up with the factory hole it is installed over.

Note: A flat screwdriver can be used to pull the head

of each fastener up if needed.

6 6

Take (3) three supplied hex head screws and install

through the holes in the MudFlap at the inner fender

with a ratchet and appropriate socket. Then, tighten

to a snug fit.

What You Need

48MF583 Parts Kit x 3

(6) Hex Head Screws

(6) U-Clips

Ratchet and Socket Set*

Trim Clip Remover*

*Not included

Page 1 Installation Instructions MudFlaps What You Need 48MF583 Parts Kit x 3 (6) Hex Head Screws (6) U-Clips Thoroughly wash your vehicle, removing all dirt, debris and stains from each fender in the areas where the MudFlaps will be installed. Ratchet and Socket Set* Trim Clip Remover* Park the vehicle on level ground.
Page 2 Install the passenger side MudFlap marked “RH,” fully tighten the (3) three supplied hex head screws. repeating Steps 3-7. Congratulations! Your new WeatherTech® No-Drill MudFlaps have been installed! Lifetime Limited Warranty against defects in materials and workmanship when installed correctly.
Page 3 Lo que necesita Matériel nécessaire 3 juegos de Trousse de pièces MudFlaps piezas 48MF583 48MF583 x 3 (6) tornillos de (6) vis à tête hexagonale cabeza hexagonal (6) agrafes en U Instrucciones (6) grapas U Juego de matraca Trousse de douilles de instalación y dados* et rochet* Extractor de grapas*...
Page 4 à tête hexagonale fournies. répétant les étapes 3 à 7. ¡Felicitaciones! ¡Sus nuevas Loderas Sin-Perforacion de WeatherTech® están instaladas! Cuando se instalan correctamente, incluyen una garantía limitada de por vida contra defectos de materiales y mano de obra.