WeatherTech 110135-120135 Instructions D'installation

No-Drill MudFlaps
1
Thoroughly wash your vehicle, removing all
dirt, debris and stains from each fender in the
areas where the MudFlaps will be installed.
2
Park the vehicle on level ground. Begin with
the driver's side MudFlap installation.
3 3
If the vehicle is equipped with factory splash guards,
proceed to Step 4. If it does not, proceed to Step 5.
5 5
View: Underside of fender
Using a ratchet and appropriate socket, remove the
(1) one factory hex head bolt at the underside of the
fender. It will be reused.
*Note: The factory plastic fastener will remain installed if the vehicle is not
equipped with factory splash guards.
Installation Instructions
4 4
View: Underside of fender
Using a ratchet, appropriate socket and supplied
Phillips bit, remove the (2) two Phillips head screws
at the inner fender in the factory splash guard. They
will be reused. Then, using a trim clip remover,
remove the (1) one factory plastic fastener at the
underside of the factory splash guard by pulling the
head up and the base out of the fender. It will be
reused. Then, remove the factory splash guard from
the fender.
6 6
Using the MudFlap marked "LH," place it up to the
fender and align with the corresponding holes.
Then, re-install the (1) one previously removed
factory hex head bolt at the underside of the fender
through the hole in the MudFlap with the ratchet
and appropriate socket and loosely tighten.
*Note: The factory plastic fastener will remain installed if the vehicle is not
equipped with factory splash guards
What You Need
Ratchet and Socket Set*
Trim Clip Remover*
Flat Head Screwdriver*
*Not included
48MF567 Parts Kit:
(1) Phillips Bit
48MF568 Parts Kit x 2
(4) U-Clips
View: Underside of fender