Publicité
Les langues disponibles
Les langues disponibles
Installation
Using the short hose as an extension
C
30
English
Untitled-1 30
1. Close the cold water tap. If you have a washer's cold
2. Using pliers, tighten the coupling an additional two-
3. Connect the Y-connector (A) to the brass male end
B
4. Using pliers, tighten the coupling an additional two-
5. Connect the angled end of the water hoses (C) to the
A
6. Using pliers, tighten the coupling an additional two-
7. If you detached the cold water hose from your
8. Open the cold water tap, and then check for any
water hose attached to the cold water tap, unscrew
and remove the hose. Then, connect the short hose
(B) to the cold water tap. Turn the coupling by hand
until it is tight.
thirds turn. Do not overtighten because the coupling
may be damaged.
of the short hose. Turn the coupling by hand until it
is tight.
thirds turn. Do not overtighten because the coupling
may be damaged.
filling valve at the bottom of the rear frame. Turn the
coupling manually until it is tight.
thirds turn. Do not overtighten because the coupling
may be damaged.
washer, attach the hose to the free end of the
Y-connector, tighten the coupling by hand until it is
tight, and then, using a pliers, tighten an additional
two-thirds turn.
leaks.
2021-10-20
11:36:46
Publicité
