DeVilbiss Healthcare Drive TSE 150 Mode D'emploi page 12

EN
LID ASSEMBLY:
The lid is preassembled at the time of delivery, but can
be replaced if necessary.
To do this, fold the lid all the way back. The lid can then
be taken rearwards out of the holders. Insert the new lid
accordingly. The lid can then be taken out of the holders.
Clip the new lid on.
6
ARMREST ASSEMBLY:
Push the armrests sideways into the armrest holders
provided for this purpose.
Now push the armrests (E) in until they catch, and then
fold them down if needed so they rest on the support
Height settings
The raised toilet seat can be adjusted using the adjust-
able holders for an elevation of 6.5 cm, 10 cm or 13.5 cm
(pic. 7 + 8).
7
8
Adjustable holders
Crossbar
Clamps
Knob nuts
It is set at 10 cm at the time of delivery. (pic.9).
12
Drive Medical GmbH & Co. KG | As per: 13.03.2023 | Errors and alterations excepted
9
If you wish to change this, follow these steps:
• Lightly push the locking tabs on the right and left under
the armrest holders and pull out the rear crossbar with
the adjustable holders. Pull out the front crossbar with
the adjustable holders likewise.
• Adjust the desired front and rear height (pic. 10).
10
• To do this, insert the crossbars in the corresponding
opening in the adjustable holder.
• Take care that the crossbars on the right and left are
each inserted at the same height.
• The front crossbar can be set lower than the rear
crossbar.
• Insert the front and rear crossbars with holders back
into the raised toilet seat. In doing so, the holders of
the rear crossbar must engage with the locking tabs
The adjustable holders can only be inserted in one di-
rection into the raised toilet seat.
6,5 cm
10 cm
13,5 cm
Adjustable holders
Crossbar
Instructions for use TSE 150 / TSE 150 Plus
6,5 cm
10 cm
13,5 cm