DeVilbiss Healthcare Drive TSE 150 Mode D'emploi page 11

Safety instructions
• Do not use if there are any defects!
• Caution – risk of slipping/falling!
• The lid must not be used as a backrest in the opened
position!
• The lid must not bear a load when closed (by sitting on
it, for example)!
• Check the raised toilet seat regularly for a secure fi t on
the toilet bowl. Retighten the knurled nuts if necessary.
• Take note of the permitted maximum weight of the user.
This information can be found in the technical data in
these instructions for use as well as on the identifi ca-
tion plate.
• Every serious incident which occurs in connection with
the product must be reported to the manufacturer and
the competent authority of the member state in which
the user and/or patient is located.
Use
The raised toilet seat TSE 150 is suitable for nearly all
standardized or commercially available toilet bowls.
Assembly
Remove the seat and lid from the toilet bowl.
Assembly is carried out without tools.
TSE 150:
Remove the hinge and lid from the toilet bowl. Assembly
is carried out without tools. To do so, set the raised toilet
seat on the toilet bowl, adjust both threaded rods M 8
(G) after removing the knurled nuts (F) to the appropri-
ate width and insert through the holes of the toilet bowl.
Depending on the length of the toilet bowl, it should be
ensured that the clamps on the rear crossbar (B) are ad-
justed in the corresponding direction such that support
of both crossbars is ensured. Screw both knurled nuts (F)
loosely back onto the threaded rods (G), align the raised
toilet seat, and then tighten both knurled nuts (F). Check
all screws for tightness and tighten if necessary. Only the
supplied fastening materials may be used for assembly.
1
C
F
G
Drive Medical GmbH & Co. KG | As per: 13.03.2023 | Errors and alterations excepted
TSE 150 PLUS:
Push the top-mounting pin
together (I) as shown in
the photo and insert down
into the mounting holes of
the ceramic bowl (pic. 2).
Place the rear of the sup-
port (B) on the ceramic
bowl and screw in the star
screws (H) from above but
do not tighten them yet. Align the rear of the support (B)
in the center on the ceramic bowl and tighten the star
screws (H)(pic. 3+4).
3
8
4
Insert the adjustable holders (C) at the desired height
(6,5 / 10 / 13,5 cm) on the rear of the support (B) on the
right and left (photo 4).
Insert the adjustable holders (C) at the desired height
(6,5 / 10 / 13,5 cm) on the rear of the support (D) on the
right and left.
Take care that the front supports (D) on the right and left
C
are each inserted at the same height.
B
The front supports (D) can be set lower than the rear sup-
port (B).
Insert body (A) of the raised toilet seat into the adjust-
F
able holders (C). In doing so, the adjustable holders (C)
must engage with the locking tabs (L) in the body (A).
G
The adjustable holders (C) can only be inserted in one
direction into the raised toilet seat.
I

C
H
Instructions for use TSE 150 / TSE 150 Plus
EN
I
C
H
B
11