Andis ORL-S Instructions D'origine page 5

15. When discarding old batteries, cover battery terminals with
heavy-duty adhesive tape to prevent short circuits.
WARNING: Do not attempt to destroy or disassemble
trimmer or remove any of its components. Also, never
touch metal terminals with metal objects and/or body
parts, as short circuit may result. Keep away from
children. Failure to comply with these warnings could
result in fire or serious injury.
16. This appliance is only to be used with the power supply unit
provided with the appliance.
17. This appliance is only supplied at safety extra low voltage
corresponding to the marking on the appliance.
18. Keep the appliance dry.
SAVE THESE INSTRUCTIONS
REFER TO PAGE 2 FOR FIGURES.
UNIVERSAL AC/DC POWER ADAPTER
The unit/charging stand is equipped with a universal AC/DC power adapter. Interchangeable input
plugs are included for use in most countries around the world (Figures A-F). Plugs may vary by model.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on plug until it releases
from power adapter (Figure G).
REPLACING INPUT PLUG:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on input plug (Figure G).
2. Gently push input plug into power adapter until it snaps into place.
OPERATING INSTRUCTIONS
• The battery is not intended to be replaced by the user.
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• The battery is to be disposed of safely.
CHARGING TRIMMER USING CHARGING STAND
The AC adapter is intended for use with Andis model ORL-S lithium-ion trimmer battery with a rated
capacity of 4.5V
into a 120V AC outlet, or according to your local power standards. Plug the adapter cord into the
receptable on the back of the charging stand (Figure H). Place trimmer in the charging stand.
The ON/OFF switch on the trimmer must be in the OFF position for the battery to charge. The blue
light on the trimmer will fade in and out while charging. Note that the trimmer can be removed at
any time during the charging cycle without harming the trimmer or battery. Once the battery is fully
charged, the light on the trimmer (Figure I) will turn solid blue.
1.2A. Remove the trimmer and AC adapter from the carton. Plug the AC adapter
5