Important Safety Instructions For Battery Packs - DeWalt DG3000 Guide D'utilisation

Important Safety Instructions for Battery
Packs
DG4400B, DG4400BC, DG6300B, DG6300BC ,
DG7000B, DG7000BC
An 18V D WALT battery pack is used to start these units using the elec-
e
tric start feature. When ordering replacement battery packs be sure to
include catalog number and voltage: Extended Run Time battery packs
deliver 25% more run-time than standard battery packs. Consult the
chart at the end of this manual for compatibility of chargers and battery
packs.
notE: Your tool will accept either standard or Extended Run Time bat-
tery packs. However, be sure to select proper voltage.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below. Then
follow charging procedures outlined.
rEAD ALL InSTruCTIonS
• Do not incinerate the battery pack even if it is severely dam-
aged or is completely worn out. The battery pack can explode in
a fire.
• A small leakage of liquid from the battery pack cells may
occur under extreme usage or temperature conditions. This
does not indicate a failure.
However, if the outer seal is broken:
a. and the battery liquid gets on your skin, immediately wash with
soap and water for several minutes.
b. and the battery liquid gets into your eyes, flush them with clean
water for a minimum of 10 minutes and seek immediate medical
attention. (Medical note: The liquid is 25-35% solution of
potassium hydroxide.)
• Charge the battery packs only in D
• DO NOT splash or immerse in water or other liquids.
WAlT chargers.
e
• Do not store or use the battery pack in locations where the
temperature may reach or exceed 105°F (such as outside
sheds or metal buildings in summer).
DANGER: Electrocution hazard. Never attempt to open the battery
pack for any reason. If battery pack case is cracked or damaged, do not
insert into charger. Electric shock or electrocution may result. Damaged
battery packs should be returned to service center for recycling.
notE: Battery storage and carrying caps are provided
for use whenever the battery is out of the generator or
charger. Remove cap before placing battery in charger
or generator.
WARNING: Fire hazard. Do not store or carry bat-
tery so that metal objects can contact exposed bat-
tery terminals. For example, do not place battery in aprons, pockets,
tool boxes, product kit boxes, drawers, etc., with loose nails, screws,
keys, etc. without battery cap. Transporting batteries can possibly
cause fires if the battery terminals inadvertently come in contact
with conductive materials such as keys, coins, hand tools and the
like. The US Department of Transportation Hazardous Material
Regulations (HMR) actually prohibit transporting batteries in com-
merce or on airplanes (i.e., packed in suitcases and carry-on luggage)
UNlESS they are properly protected from short circuits. So when
transporting individual batteries, make sure that the battery terminals
are protected and well insulated from materials that could contact them
and cause a short circuit.
The rBrC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corp-
oration) Seal on the nickel cadmium and nickel metal
hydride batteries (or battery packs) indicate that the
costs to recycle these batteries (or battery packs) at the
end of their useful life have already been paid by
D WALT. In some areas, it is illegal to place spent
e
nickel cadmium and nickel metal hydride batteries in the trash or
municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
10