Flex FX1671 Manuel De L'utilisateur page 14

DIRECTION-OF-ROTATION (FORWARD/
CENTER-LOCK/REVERSE) SELECTOR
WARNING
selector in the "OFF" position (center-lock)
to help prevent accidental starts and
possible injury.
Your tool is equipped with a direction-of-rotation
selector, located in front of the variable-speed
trigger switch. This selector is used to change
the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock)
position.
a. Position the direction-of-rotation selector to
the far left of the tool for forward rotation
(Fig. 9).
b. Position the direction-of-rotation selector to
the far right of the tool for reverse rotation
(Fig. 9).
c. Position the switch in the "OFF" (center-
lock) position to help reduce the possibility of
accidental starting when not in use.
TURBO MODE
In turbo mode the tool delivers higher rotation
speed. The torque remains the same.
NOTE: When operating in turbo mode, the tool
depletes the battery pack charge faster.
NOTE: The turbo mode cannot be activated or
deactivated while the tool is in operation.
Press the turbo function button to activate
the turbo mode of the tool. The turbo function
indicator light will light up at the same time.
When you press the trigger switch the tool will
operate in turbo mode (Fig. 10).
To turn off the turbo mode, release the trigger
switch, and then press the turbo button. The
indicator light will turn off and the tool will return
to its "normal" mode.
ADJUSTMENTS
After tool use, lock the
direction-of-rotation
Fig. 9
NOTICE: To prevent gear damage, always
allow the tool to come to a complete stop before
changing the direction of rotation.
NOTICE: The tool will not run unless the
direction-of-rotation selector is engaged fully to
the left or to the right.
Fig. 10
Turbo Function
Indicator Light
-14-
Turbo Function
Button