Flex FX1671 Manuel De L'utilisateur page 13

INSTALL AND REMOVE HOOK
The hook is included with the tool but requires
installation.
To install the hook
1. Lock the variable-speed trigger switch "OFF"
on the tool by placing the direction-of-rotation
selector in the center position.
2. Remove the battery pack.
3. Align the base of the hook with the hook
mounting spot.
4. Use the Phillips head screwdriver (not
supplied) to tighten the two screws (Fig. 8).
Make sure that the hook
WARNING
is properly secured to the
tool with two screws.
To remove the hook
Use the Phillips head screwdriver (not
supplied) to loosen the two screws and remove
the hook.
Never hang the tool using
WARNING
the hook at high location
or on potentially unstable surface.
Once the hook is installed, the drill can be
carried or hung on a rope, nail, and a 2x4 or
Fig. 8
Hook
Two
Screws
3x6 piece of wood.
To use, lift the hook up until it snaps into the
desired open position – there are two open
positions available.
When not in use, always lower the hook until it
snaps into the closed position (Fig. 8).
Do not use damaged hook and screws. Before
use, always check for damages, cracks or
deformities, and make sure that the screws are
tightened.
-13-