Xingbang AH60A-L8B Manuel D'instructions Utilisateur page 33

Installation
Installing the chimney
Ensure that sufficient clearance is left between the ceiling and the
Important!
wall bracket for the mains cable if necessary.
1. Hold wall mount 5 horizontally up to wall at favored chimney height in such a
way that the middle of the wall mount and the vertical aid line align. Draw the
two drill holes.
2. Drill two holes in the wall with a diameter of ø 9 mm at the marked spots.
3. Drive two wall plugs 8 in the drill holes.
4. Attach top wall mount 5 with two screws 9 to upper plugs.
5. Slide top chimney section 3 on bottom chimney section 4 and put it on
extraction hood.
6. Attach two screws 6 through the side holes of bottom chimney section 4 to
extraction hood.
7. Pull out top chimney section 3 upwardly and attach it with two screws 6 to
wall mount 5.
8. Lead power cable covered within chimney sections to socket and plug power
cable into socket.
9. For extraction mode, connect the top end of exhaust air hose with wall
breakthrough and fasten exhaust air hose to hose clamp (not included in the
scope of delivery).
8
9
5
Preparation
Guide line
3
6
4
English
13