Publicité
Les langues disponibles
Les langues disponibles
OPERATION - General
The appliance is intended only for
domestic use, not for professional use.
1. Fan housing
2. Fan blades
3. Stand with non-slip feet
4. Adapter
5. Control panel
6. Speed switch
7. Charging lights
OPERATION - Before first use
Remove the fan from the packaging and remove all packaging materials.
OPERATION - Charging the battery
1. Open the charging port by removing the rubber cap and insert the plug of the adapter
into the charging port of the fan (see figure 2).
2. Plug the adapter into the socket. The full charging time of the battery is about 2 hours.
Each indicator light indicates the charging status of the battery at 20% intervals, up to
a maximum of 100%.
3. Allow the fan to fully charge up to 100%. The adapter can get a bit warm. This is
normal and does not indicate a defect. If you don't unplug the adapter after the fan is
fully charged, all the charging lights will switch off automatically after 20 minutes.
4. Remove the adapter plug from the charging port and remove the adapter from the socket. Then close
the charging port by replacing the rubber cap.
OPERATION - Ventilate
3
1
1.
Put the fan on a horizontal and clean floor.
2.
Point the front of the fan in the direction which you wish to
ventilate. You can also adjust the fan to obtain a slightly downward,
horizontal, or slightly upward ow of air, tilt the fan housing to the
required angle (see figure 3).
3.
Switch the fan on by turning the speed switch to the + position to
the desired speed.
4.
Reduce the speed by turning the fan to the - position.
5.
Turn the speed switch back to OFF, to switch off the fan.
20
7.
6.
1.
5.
2.
3.
4.
2
in
EN
Publicité
