Publicité
Les langues disponibles
Les langues disponibles
Read and save these instructions.
Introduction
The T6 Pro Z-Wave Programmable Thermostat is a Z-Wave Plus certified thermostat
capable of controlling up to three heat and two cool stages of heat pump, (incl. dual
fuel heat pump systems) and up to two heat and two cool stages of conventional
system (3H/2C HP, 2H/2C Conv.) It also measures, displays and reports % indoor
relative humidity; however, this model does not control humidification equipment.
It is one of the easiest smart thermostats to install and is controllable by all Z-Wave
compliant controllers that have the control capability for "Thermostat" devices.
When integrated with the app that controls your Z-Wave controller, it lets you pro-
gram and control your home's HVAC system as well as controlling other Z-Wave
devices connected to the same Z-Wave controller.
The T6 Z-Wave thermostat has Dynamic Capabilities configuration settings which
can be adjusted from a Dynamic Capabilities enabled controller in the network.
Parameters that can be adjusted:
• Thermostat Mode
• Fan Mode
• Set Point Mode
If the ISU settings for system type or cooling stages are changed on device or
through a Z-Wave controller, the available settings may change. See "(ISU) Advanced
menu" section in this guide.
NOTE: Some controllers will require the thermostat to be rediscovered or removed
and then included again in order for configuration changes to be reflected.
Because the thermostat is battery-powered, low-voltage integrators
can easily connect the thermostat to most HVAC systems. Optional
24 VAC powering via "C" or common wire is also available, if desired.
CAUTION
• We strongly recommend that installation is performed by a trained HVAC
technician.
• Read the enclosed instructions carefully before installing the new T6 Pro Z-Wave
Programmable Thermostat.
• ELECTRICAL HAZARD: Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.
• To prevent abnormal operation, it is highly recommended to configure the
installer setup and set the thermostat to correct HVAC system before including the
thermostat to Z-Wave network. If the configuration must be changed, first REMOVE
the thermostat from the network, change the thermostat configuration, and
INCLUDE the thermostat back to the network.
• Before disconnecting wires from the existing thermostat, label the wires with the
terminal markings from the old thermostat and record them. Take a picture of the old
wiring.
• Use 3 new AA batteries in the thermostat.
2
Publicité
