Waeco AirConServiceCenter ASC5500G RPA Notice D'utilisation page 123

ASC5500G RPA
"Service completed" displays the amount of service work performed
using the air conditioning service unit since the last reset (see date).
9.4.1 Entering the filter code
To reset the filter counter, you need to enter a 12-digit code. This special
code is located on the new filter. A "Code entry" prompt appears in the
menu. If a code is not entered, the unit is taken out of operation. Each
code only works once.
9.4.2 Leak test
After changing the filter, perform a leak test with an approved testing
device.
EN
Service completed:
Number
STOP-EXIT
Service tasks
08/03/17
4
123