Télécharger Imprimer la page

LG LRSWS2806 Serie Manuel D'utilisation page 17

Masquer les pouces Voir aussi pour LRSWS2806 Serie:

Publicité

Les langues disponibles

Les langues disponibles

en-us_main.book.book Page 17 Friday, February 10, 2023 11:43 AM
• Make sure the house water valve is fully open. If
it is not open completely, the icemaker and
dispenser may not work properly.
Leveling and Door
Alignment
Leveling
The refrigerator has two front leveling legs. Adjust
the legs to alter the tilt from front-to-back or side-
to side. If the refrigerator seems unsteady, or the
doors do not close easily, adjust the refrigerator's
tilt using the instructions below:
1
Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
NOTE
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
2
Open both doors and check to make sure that
they close easily. If the doors do not close
easily, tilt the refrigerator slightly more to the
rear by turning both leveling legs to the left. It
may take several more turns, and be sure to
turn both leveling legs the same amount.
Door Alignment
Both the left and right refrigerator doors have an
adjustable nut, located on the bottom hinge, to
raise and lower them to align properly.
If the space between the doors is uneven, follow
the instructions below to align the doors evenly:
Use the wrench (included with the owner's
manual) to turn the nut in the door hinge to adjust
the height.
1
Open the door and use the wrench to loosen
the keeper nut by turning it to the left.
2
Use the wrench to adjust the height by
turning the adjustment hinge pin to the right
to raise the door or to the left to lower it.
3
Use the wrench to fasten the keeper nut by
turning it to the right.
CAUTION
• Do not overtighten the door adjustment screw.
The hinge pin can be pulled out and the
adjustable range of height is a maximum of 2 in.
(5 cm).
Turning on the Power
• After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
INSTALLATION
17

Publicité

loading