Assembly; Tools And Materials Required; Assembly Example; Preparation For Assembly - Garant System-Arbeitsplatz Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4.

Assembly

Depending on the configuration, the workbench consists of various
components, e. g. support legs, unit shell (e.g. for drawer units) and
optional accessories which have to be assembled.
The worktop is provided with holes only for the standard arrangement of
support legs and drawer unit shells. If the arrangement of support legs and
drawer unit shells is non-standard, the necessary holes must be drilled in
the worktop.
Diameter: 5 mm
X 
Depth: 20 mm
X 
The frames of the workbenches GARANT system workstation, GARANT
KOMPAKT (except 930950) and GARANT KOMPAKT L + H are supplied fully
assembled. The GARANT system workstation is supplied with the fittings
also assembled.
4.1.

Tools and materials required

Tool / Material
Size / Quality
5 AF, 6 AF
13 AF
PH2
for floor anchoring (in BN25 concrete)
Plastic, size 8
Size: 6 × 50
Strength: min. 8.8
26
4.2.

Assembly example

The following assembly is based on the example of a GARANT KOMBI
workbench.
4.2.1

Preparation for assembly

Secure the erection location for the workbench.
X
X
Make sure that the floor, on which the workbench will be erected,
X
X
is level, clean and dry.
If necessary for protection
X
X
of the worktop working
surface, place an underlay
(a) on the floor.
Place the worktop on the
X
X
floor with the working
surface facing downwards
so that the "Front"
sticker (b) is visible and at
the front.
4.2.2

Mount the support legs to the worktop

If the assembly position is non-standard:
X
X
If necessary, mark out the non-standard holes.
X 
Drill the holes.
X 
Place the support leg(s)
X
X
precisely over the
pre-drilled holes and screw
them on.
For fitting the rear panel
X 
and/or storage shelf:
Screw the support legs
on, but do not fully
tighten them.
If necessary, fit the further
X
X
support leg in the same
way.
a
b
27
DE
EN
ES
FR
IT

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

KompaktKompakt l + hKombiKombi sechseck-werkbank

Table des Matières