CombiSteel 7178.0505 Manuel D'utilisation Et De Maintenance page 5

Gas Connection
 Device should be connected in accordance with the national and local gas standards of
the relevant country.
 The device should not be directly connected to the tube.
 Gas inlets "GAS" of the device are indicated with a label on device body.
 Connection to the gas installation should be made with flex pipe and ball valve. Fix the
said ball valve to a place that is away from heat and easily accessible in case of a danger.
 Flex connection pipe should be preioudically replaced every 5 years.
 After gas inlet connection is completed, check for possible gas leakages.
 Feed the device with the gas and pressure as specified on device information plate and
adjusted. If the gas type to which the device was adjusted for is not suitable to the gas
type at the mounted place, follow the instructions written below.
ATTENTION: All adjustments and modifications to be performed on the gas installation and
connection of the device should be performed by authorized people.
ADJUSTMENT ACCORDING TO DIFFERENT GAS TYPES

If the device is connected to gas installation, close main gas inlet valve.

Replacement of top burner nozzles (Figure B)
a. Remove cooker grater (1), top burner cover (2) and oil tray (3)
b. Replace nozzle (5) with a nozzle suitable for the gas type
c. Adjust the flame of the pilot burner by turning the bolt (4)
D. OPERATOR INSTRUCTIONS AND ATTENTION POINTS
 Make sure to turn the device on and wait before attempting to cook. This will ensure the
evaporation of the protective oil on top.
 When you do not cook, keep the adjustment button on "
more economical usage for you
 Check the water level in the drawer periodically. Replace the water if the water level is
down.
 Clean the grill mouldings everyday with a suitable tool. This will help clean the
carbonized and burned food residues and will ensure the cooking efficiency.
 Oil cabinet should be cleaned after usage each time.
 If the buyer intends not to use the grill for a long period of time, the grill mouldings
should be oiled and stored in a place with no humidity.
 The back-side chimneys should not be blocked at any time.
 The water-oil mixture can be discharged from the discharge valve at the back of the
device.
 No food should be left at the cabinet part of the unit.
START-UP
 Put water in the water cabinet (7) (Figure C) – 5lt. Do not start-up with no water inside.
 Turn on the main gas valve.
 Put the grill gas button (5) to "
" position.
5
" position. It will provide a